How Do I Repair My Car Antenna Cable End

How to Splice a Car Radio Antenna

past Billy Brainard

coaxial cable connectedness image by Michael Shake from Fotolia.com

Car antennas operate using coaxial cable to connect the antenna to the radio, so repairing or splicing is similar to any other project using coaxial cable. Splicing ane cable to another allows you to bring together two divide cables together into one connection. The cable consists of an outer prophylactic insulation, a wire mesh, a plastic insulator, and the heart usher wire. Using a butt plug to splice the two ends of the cables together volition ensure a solid connectedness.

Footstep 1

Turn off the machine and remove the fundamental from the ignition. Pop the hood on the car and remove the positive (red) battery cable from the bombardment concluding. This will ensure there is no electric current following through whatsoever of the wiring in the automobile.

Footstep ii

Locate the 2 ends of the auto antenna to be spliced together. Cut a i/four-inch off each finish of the cables to ensure the finish of the cables are clean with a fresh cut.

Step three

Insert the end of one of the cables into the larger hole on one end of a cablevision stripper tool. Strip off i inch of the outer insulation. Flip the tool over to the other stop and insert the same cable into the smaller hole and strip off a 1/2-inch inch of wire mesh and plastic insulator, to betrayal the center conductor. Echo this step to strip the end of the other coaxial cablevision.

Pace 4

Slide the stripped end of one of the cables into the end of one of the male connectors. Place the crimping tool over the bottom of the male connector and clasp the handles of the tool together and so the jaws of the tool clamp downward on the connector and presses the connector to the cable. Repeat this step to attach the remaining male connector to the other cable.

Step 5

Screw one of the male connectors into ane terminate of the butt connector. Spiral the other male connector into the other cease of the barrel connector to complete the splice. Apply the wrench to tighten the connectors to the barrel plug. The barrel connector is a pocket-size fitting that has 2 female threaded holes on each side. It will let you to join to the ii male connectors on each stop of the cable together.

Step 6

Wrap electric record over the connectors, starting on ane cable and finishing the wrap on the other cable.

Reconnect the battery cable to the bombardment and tighten it downwardly. Insert the key into the ignition and plough it to accessory fashion. Plow the radio on and test the antenna for performance by tuning in various stations.

References

Tips

• It may be helpful to purchase a coaxial cable connector splicing kit to complete the project. The kit will incorporate all the tools and connectors needed for this project. Or you can purchase each of the tools and connectors separately. Each should be bachelor at a local hardware or electronics store.

Things You'll Demand

• Adjustable wrench
• Cablevision cutters
• Coaxial cablevision stripper tool
• 2 male coaxial connectors
• Coaxial cable connector crimping tool
• ane male-to-male barrel connector
• Electrical tape

Warnings

• Avoid touching the positive (cherry-red) and negative (black) battery cables together or assuasive the wrench to touch the two battery posts simultaneously, as this could consequence in electrical sparks or a fire.

Writer Bio

Billy Brainard graduated with a Bachelor of Science degree in education from Trinity College. As the department chairman he was responsible for creating and writing the curriculum for seven-12 grade students. Currently he writes for eHow and works function time helping employees by creating and writing resumes to help in their job search.

More Articles

How Do I Repair My Car Antenna Cable End,

Source: https://itstillruns.com/splice-car-radio-antenna-6304651.html

Posted by: dayalaitur.blogspot.com

Share this post